[Stealth Man]

Yes, the magnets are powerful being rated at +5000 gauss.

The key is to “crack” the two smaller clasping magnets apart with two thumbs centered in the middle, and the fingers on the opposite outside ends as if you were snapping a pencil in half.

Pulling them apart would not work as you have discovered!

The first week or so I also had dramatic size fluctuations of both the penis and ballsack. For this reason, it is recommended to test the fit for a few days before deciding to shorten the silicone tubing to avoid making the fit too tight.

[Stealth Man]

Happy to have you contributing here as well Ujjayi… welcome!

You can also experiment with the spandex sleeves by wearing them covering the glans as seen in the pic below.

[Stealth Man]

Ujjayi,

You are in the midst of the learning curve.

The only time I have had any problem wearing Stealth to sleep was from the constriction of early morning erections caused during testing of new designs or combinations of sleeves, Retainer bands, Sabre Skins, etc. that were too tight.

Urination is possible when standing up. The fit should be dialed in properly otherwise if the urethra is stretched or compressed too thin. This will result in a burning sensation which causes the body to stop the flow of urine.

I have experienced the sideways stream on occasion as well, but this has not been a regular problem for me.

If I am wearing the spandex sleeves or Sabre Skin, I generally remove them to ensure complete elimination of urine. If you rush the completion, you will be likely to experience leakage or even a spurt of urine with a sneeze later on. When this happens, it is very uncomfortable and potentially embarrassing. The trick is to take time to relax and eliminate with 2-3 extra contractions of the PC muscle than usual.

Make sure you take a break for a few hours or overnight if you experience any pain or irritation wearing Stealth. The sooner you rest, the sooner you can resume wearing again.

 

 

 

 

 

[Stealth Man]

Ujjayi,

Not sure what you mean by wrinkled. Can you describe in more details?

There is often an initial conditioning period for new users in which irritations may develop if overused from the get-go. The key here is to take rest for a few hours or overnight if any redness or irritation begins to occur. The sooner you rest the sooner you can resume wearing the device again. After three or four weeks the sensitive skin of the anatomy will have adapted and the fabrics molded for a more compatible and comfortable fit.

It might be compared to wearing a new shoe for which a break-in period is required before everything settles in.

[Stealth Man]

Good points Whaim,

As far as elegance goes I think the O-ring is the simplest, most streamline and cost-effective method. Any kind of threading would not be possible on the magnet. Although a metal insert might be possible the added bulk would be a real challenge.

We are expecting delivery of the instructions any time now. Meanwhile, you can access the file here…

[Stealth Man]

Great Feedback Ujjayi!

Take your time experimenting with the set-up as you move thru the learning curve. Soon you will have it dialed in and set up will become a breeze.

I agree the feeling of weight and heft is pretty amazing.

The weighted kegel is a great idea!

If you want to protect the exposed glans from friction you can wear one of the spandex sleeves left covering the glans as an artificial foreskin.

Use care when wearing the Corkscrew during physical activity.

All the best!

[Stealth Man]

Stealth enthusiasts have literally mentioned a number of times “I never leave home without it” and for the first 4-5 years I also never left home without it and even at night, it was important for me to wake up with it on.

[Stealth Man]

Thank-you for the kind words Stephen… I find it helpful knowing that members here appreciate the time and effort being invested to bring new products to market.

With respect to the metals used to make the Mag-Volts.

Silver is a nobler metal (cathodic) and is rated higher on the Galvanic corrosion chart as it is more stable and less likely to corrode. Whereas zinc being the active or less noble metal (anodic) corrodes by giving up electrons which pass across the salt bridge created by sweat to complete the circuit. Copper being noble than Silver with a corresponding lower rating on the corrosion chart should, in theory, generate a lower voltage. However, in testing, they both had the same reading at around .75 volts, more or less, depending on the fluctuations on the voltmeter reading. The highest reading I was able to measure was .9 volts.

If you are interested you can read more on the topic here…

https://www.zygology.com/cms/upload_area/pdf/Zyg-Anodic-Index.pdf

and here…

https://www.thoughtco.com/galvanic-cell-definition-604080

As to the trivia you mention…

Yes, the Mag-volt I wear fits my wrist exactly right!

 

[Stealth Man]

thanks for the compliments guys!

I find the pouch style offers more freedom which supports the full potential of the package. Paired with Levi’s 501 button fly which fit roomier in the crotch not only keeps the bulge less explicit in detail but also allows just enough movement that when walking it can make for an arousing experience. If I am also getting outside attention, then it can be quite stimulating. Whereas the tighter fitting combinations tend to lock down the equipment and not produce the same type of experience.

[Stealth Man]

Interesting point that you bring up. I will keep this in mind when coming close to metal objects.

Sounds like a great test of your ability to maintain composure during a highly distracted state. Well done!

The magnets are very powerful as can be noted when connecting and disconnecting the two smaller clasping magnets.

The early prototypes that I tested were zinc and copper plated magnets. In this case, all four beads were magnetic. I was sitting at a restaurant table eating with a few others when I felt a sudden pinch with intense burning pain. I figured the silicone tube next to the metal bead was pinching the ball sack and excused myself to go to the men’s room to investigate. The side and bottom magnets had attracted one another thru the ballsack and snapped together causing great pain. I knew then that this was not the way to go and to separate the magnets with solid zinc beads on either side.

[Stealth Man]

There is a learning curve with the Corkscrew so you don’t want to push too fast too soon and deal with the unexpected!

[Stealth Man]

this pic is with the D24… thanks, but maybe I gain some advantage with the camera perspective as well 😉

[Stealth Man]

I am a fan of Stanfield’s pouch style underwear.

[Stealth Man]

good to hear Ian!

Experimentation is the key to find the best set up and clothing combinations.

[Stealth Man]

The appearance can be controlled to a great extent with the underwear selection. I am a hardcore Levi 501 button jeans guy. These days the size I wear is roomier in the crotch which pairs well with the pouch style Stanfield’s underwear I currently use. The pouch style shows more than the tighter fitting underwear without too much clarity of form with the 501’s. However, I typically wear my shirt untucked which maintains a more conservative look overall.

[Author]

Posts