Good to have you back UmbralDragon!
Thanks for sharing your experience with Stealth and the multiple layering.
The interstitial fluid build up is a good indictor of the inner wear set-up being too tight. The only time I experienced this was during the testing phase of the spandex sleeves while sleeping. I was waking up with a pretty massive penis head and was both alarmed at the sight and excited with the prospects of experimenting with it more.
Did not really follow up on that as I for the most part stopped wearing the spandex sleeves on top of the inner wear to bed. I have noted since that when the spandex sleeves are properly broken in that the interstitial fluid did not happen when on occasions when I forgot and wear them to sleep.
What you can do is send a message to the [email protected] email support mentioning the silicone sleeves. Then we can have your previous orders linked up with the same email for easy reference.
Thanks for the tip using athletic tape Tekcon.
You can also try tightening coils along the entire shaft or focus on different sections of the shaft to help distribute the grip load.
Tekcon,
With a bit of practice you will be able to manage the few steps in the sequence required to first get it on, then tighten the coils to wear, remove and reform the distorted coils after use in preparation for the next time you want to wear.
You can also experiment with screwing the Corkscrew into place without the using the spandex sleeves to thread the coil onto the shaft of the penis.
The Corkscrew also comes at maximum length so if you feel you would prefer a lighter smaller profile that is easier to manage and conceal you might want to consider removing one coil at a time to find your preferred length. This will be much better if you plan on outings while wearing it.
Use a box cutter to trim and the PVC end cap to seal the wire.
For your reference I have attached a pic of the D24 with two coils removed.
Understood.
The method of pumping for length requires the penis to make contact with the walls of the cylinder thereby shifting the vacuum to the space above the glans to create a more powerful “pull”. Â The sleeve basically adds girth to the shaft of the penis so that it can make contact with the walls of an otherwise slightly wide cylinder.
The fabric sheath may be very well suited to air pumping and add some particular qualities to the session whereas water pumping would probably be bettered served by using the silicone sleeve. However this would need to be tested to know which is more effective or at least preferred in either case.
Do let us know if you get a chance to test and find out!
The sleep test will definitively determine if the fit is too tight or not. You should wear the inner wear alone and see if you can sleep thru the morning wood without being woken up by any discomfort.
There is absolutely no danger here as your penis will be fully engorged with fresh blood. In my experience you will just end up pulling it off and going back to sleep without fully waking up.
When properly fitted you will sleep soundly and then after the material has broken-in for a more comfortable fit you can even layer one of the spandex sleeves and wear the Retainer band as well.
With experience you will know how to optimumize your set-ups to get the best performance.
The sleeve materials were selected from a wide variety of samples to find the ones that did not fray. The fuzz that you see forming is at the cut ends of the thread only. You can carefully trim the fuzz off with a sharp pair of scissors for a clean finish nice again. After you do this 2-3 times the fuzz will no longer appear.
We tried various methods of sewing an edge but the finish is not so nice and more importantly the function was compromised.
Andreas,
The snaps are male and female which are in effect riveted into place on the fabric. You should be able to press snap them together… no?
I personally don’t use or even attach the “rivets” anymore as I no longer use the tighter band setting. Another purpose of the buttons is to secure the folds of the base band together so that first time users can see how the base band should be set-up for use.
ok seems there is some interest in the silicone sleeves. Can you guys let me know your girth as we have a couple extra prototypes available in a specific size.
Frankfurter2… definitely contact us on the support email to help make the proper size selection and get a discount on the properly sized replacement.
Tekcon,
To get the inner wear on efficiently takes some practice however, if the size is not correct and the fit is too tight it will be painful. You do need to take into account that the materials will break in for a more comfortable fit after a week or so of regular use but if you are clear that this is simply not the case and a resize is what you need then please contact us at the support email to sort out your size requirements for a discount replacement.
We are currently out of stock on a number of the Corkscrews and we have just shipped new inventory out from the factory so this will be resolved once the sea freight lands and clears customs.
Sorry for the inconvenience and please note that you will be getting some freebies to compensate for the delay.
Christian,
If you are slipping back inside the sheath then you definitely need to make some adjustments. Sounds like you might be requiring a custom cut sheath that is the same girth as what you have now but with a smaller silicone ring to maintain a secure grip behind the glans…??
I sampled the content amazon’s “look inside” and see the book is comprehensive, clearly written with excellent demo pics. Considered to make a purchase until I noticed that the price was over $2000 for a new hard or soft cover!
Yes.. the Extension Sleeve and the regular inner wear with base band as well are designed to help promote length gains. The difference here being the 100% cotton fibre sheath still allows the skin to breathe naturally whereas the silicone sleeves do not.
welcome aboard vampire5009!
azmike is absolutely correct… do not let your size selection be influenced by anticipated gains in the future. You need the right fit to get the best performance from the Inner wear.