do you guys have a video on how to fix/resize your magvolts?? mine broke (the metal bit came off) and I have been sent a fix kit, but I dont know how to do it
any advice would be great
When mine arrived it was to *cough* small to fit around my genital mass. Is there a way to buy an extension set?
Sorry, we do not have a video at this point.
The resize kit comes with a 12″ length of superior quality tubing that has the ends tapered for insertion thru the beads.
Once you have the tube threaded with beads, you can stretch the tube to move the beads around more easily.
You should orient the clasping magnets together with the large magnet at the bottom, by first clasping the smaller two together and then connecting both side by side with the larger magnet at the bottom.
The proper orientation will be obvious once you test.
Roll the O-rings down the tube and insert the tube over the nipple and after you have tested and are sure of the fit, remove the tube and apply a small amount of the glue to securely bond it with the nipple. Then roll the O-ring over the high point of the nipple and into place against the magnet.
Wipe any excess glue off the magnet and O-ring and let sit for one hour before use, full cure takes 24 hrs.
While using, do not pull directly on the tube to remove the Mag-Volt, instead, break the connection as you would snap a pencil in half. This will make it much easier to pull apart.
Make sure that you always dampen the clasping magnets when connecting them together, otherwise, you risk having them jump out of the fingers due to the high powered magnetic attraction, which can result in chipping.
There is a couple of thin silicone pad included with the kit, use one to adhere to one of the clasping magnets to help dampen the speed of contact. Do not use both pads, just one is enough.
A good method for connecting is to hold the clasping magnets in such a way that the fingers make contact with each other first, then you will be able to easily control the impact on contact.
What’s a mag-volt?
The Mag-Volt is an electromagnetic device that is an evolution on the Blakoe ring, ball zinger, and ring of power. These devices relied solely on the galvanic current generated via corrosion of zinc in conjunctionÂ with copper. A mild .8 volt current occurs due to the ionic reaction that takes place when the salt bridge of sweat completes the electrical circuit.
We have incorporated using the magnetic field into our design which also serves as a clasp to make the ring to conveniently connect behind the genital mass next to the body.
We had some issue with chipping due to the uncontrolled impact of the high powered clasping magnets as they tend to jump out of the fingers when making contact. We have come up with a solution using a thin 0.5mm silicone disk on one of the clasps. However, the adhesive becomes soft with the body heat and the disk tends to shift out of place in use.
We are currently testing some alternative designs which will offer a higher quality standard than the adhesive silicone disk. Once this has been sorted out, we have the official relaunch.
If you are interested in the design we have now let me know on the support email at firstname.lastname@example.org and we can arrange for a discounted on the already inexpensiveÂ price of $35 for the copper version and $40 for the silver.
Here is a pic of the copper version with siliconeÂ disk.
What is the Mag-Volt?
During the 1930s, the anatomist and physiologist Dr. Robert Blakoe, invented an electromagnetic device known as the Blakoe ring. He conceived of the idea to help patients suffering from weak bladder control by stimulating the muscles to improve function. During his studies, an unexpected and remarkable side effect was occurring with his patients â enhanced sexual function. Their erections were stronger with greater stamina, ejaculate volume and intensity had increased dramatically. In other words, they were having better sex with more powerful orgasms!
Naturally, the patients were delighted; however, the idea behind the device was not fully appreciated and subsequently forgotten. This amazing invention was left in relative obscurity until early 1970 were when a few interested doctors decided to conduct a full-scale medical trial to ascertain the effectiveness of the device. The study trials concluded that the ring is based on a sound scientific principle.
The superior design of the Stealth Mag-Volt is more economical, comfortable, and convenient to wear than any of its predecessors. It is based on the original Blakoe principals and other more recent versions developed for the penis enlargement (PE) community in the early 2000s i.e. the ball zinger and ring of power. However, Stealth has gone a step further with the new magnetic components for added therapeutic benefit. The magnets also serve as a simple method to put the device on and off to wear.
The science that powers the Mag-Volt.
The Mag-Volt is essentially an electrochemical device that utilizes two dissimilar metals that when joined together by a salt bridge complete a circuit that can generate a mild electrical current.Â While electrical potential is possible with several metals, pure zinc, copper or silver have been chosen for their biocompatibility as described later in the notes.
When immersing a Zinc bar (Zn) in a saline solution, the Zn loses an electron more readily than a Copper (Cu) or Silver (Ag) bar.Â Â When the two metals are connected by a salt bridge and an electric conductor, they form a closed circuit for electrons and ions to flow as a result of the spontaneous redox reaction. This is called a galvanic cell and the chemical equation is represented as Zn / Zn2+ // Cu2+ / Cu or Zn / Zn2+ // Ag2+ / Ag.Â Â The copper or silver ions gain an electron (oxidation), and zinc loses an electron (reduction). The chemical to electrical conversion can be measured at the conductor terminal to show a maximum of 1.10 volts DC for copper and 1.56 volts for silver.
When wearing the Mag-Volt, the body sweat acts as a salt bridge to generate an electrical current withÂ three magnets for the added benefit of the magnetic field. The combined electromagnetic field improves metabolic function at the cellular level for accelerated healing, increased testosterone production, harder longer lasting erections with more powerful orgasms.
Additionally, the available Zinc supplementation supports the enzymes that regulate cell division, growth and wound healing.Â Copper contributes as an anti-ageing factor which works in tandem with Zinc to balance the uptake of either element into the body. Silver is a known Ayurvedic agent for increased strength and stamina, an anti-inflammatory with antiseptic properties.Â Although the amount of zinc, copper and silver ions released by the Mag-Voltâ¢ are small, the health benefits are substantial.
Wearing the Mag-Voltâ¢
The flexible silicone tube of the Mag-Voltâ¢ makes it comfortable to wear 24 hours a day. Once the size has been adjusted the device will not be noticeable when wearing. However, pubic hairs may get caught between the magnetic clasp. To avoid this, trim the pubic hair at the base of the genitals. Initially, the Mag-Volt should be worn 4-8 hours in duration and then increasing up to 24 hours a day with more experience. Some users prefer to wear the Mag-Voltâ¢ only at night for improved erection quality. Use during sex will amplify the intensity and duration of the erection along with more powerful orgasmic contractions with an increased quantity of ejaculate. PE practitioners will appreciate the reduced healing time required for post-session recovery.
Benefits of the Mag-Voltâ¢
The most common benefits expressed in theÂ popular PEÂ forums, based on anecdotal experience, are summarized as follows:
1-Improvement in blood circulation for prolonged, rock hard erections.
2- Enhanced sexual performance with a reduction of impotence.
3- Increased testosterone, sperm production, with more powerful orgasms
4- Increased flaccid penis size and scrotum mass.
5- Faster healing and subsequent recovery afterÂ PEÂ exercises.
That sounds really interesting. Why is it not on the site?
We are working on an improved design that we want to relaunch before offering on the site as a regular purchase. The clasping magnets on the original design were chipping due to their high power which caused them to jump out of the fingers when making the connection. At present we use the silicone disk as seen in the above pic, however, the adhesive softens with body heat which allows it to slide off centre. It works to help cushion the impact and prevent chipping but we are working on the improved design which will not require the silicone pad.
You must be logged in to reply to this topic.